InFocus IN5542 - IMAGE Menu; ASPECT; OVER SCAN; V POSITION

34
IMAGE menu
IMAGE menu
From the IMAGE menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor
button on the projector or remote control, or ENTER
button on the remote control to execute the item.
Follow the instructions below.
Item Description
ASPECT
Using the ▲/▼ buttons switches the mode for aspect ratio.
For a COMPUTER signal
NORMAL
ó
4:3
ó
16:9
ó
16:10*
ó
SMALL*
ó
NATIVE*
ó
FULL*
For an HDMI or DVI-D signal
NORMAL
ó
4:3
ó
16:9
ó
16:10*
ó
14:9
ó
SMALL*
ó
NATIVE*
ó
FULL*
For a Video signal, S-video signal or component video signal
4:3
ó
16:9
ó
16:10*
ó
14:9
ó
SMALL*
ó
NATIVE*
ó
FULL*
For no signal
4:3 (xed, except IN5544/IN5544c) / FULL (xed, IN5544/IN5544c)
• *16:10 / FULL: IN5544/IN5544c only. NATIVE: Except IN5542/
IN5542c. SMALL: Except IN5544/IN5544c.
• The NORMAL mode keeps the original aspect ratio of the signal.
OVER SCAN
Using the ◄/► buttons adjusts the overscan ratio.
Small (It magnies picture)
ó
Large (It reduces picture)
• This item can be selected not only for a video, S-video and component signal but also
HDMI and DVI-D signal when the VIDEO is selected on the DIGITAL FORMAT item (

37
) .
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In this case, please adjust small.
V POSITION
Using the ◄/► buttons adjusts the vertical position.
Down
ó
Up
• Over-adjusting the vertical position may cause noise to appear on the screen. If this
occurs, please reset the vertical position to the default setting. Pressing the RESET
button when the V POSITION is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, S-video signal, or component video
signal of 480i@60 or 576i@50 input the adjustment range depends on the OVER SCAN
(

above
) setting. It is not possible to adjust when the OVER SCAN is set to 10.
• This item cannot be selected for an HDMI or DVI-D signal.
H POSITION
Using the ◄/► buttons adjusts the horizontal position.
Right
ó
Left
• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
occurs, please reset the horizontal position to the default setting. Pressing the RESET
button when the H POSITION is selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, S-video signal, or component video
signal of 480i@60 or 576i@50 input the adjustment range depends on the OVER SCAN
(

above
) setting. It is not possible to adjust when the OVER SCAN is set to 10.
• This item cannot be selected for an HDMI or DVI-D signal.
(continued on next page)