EonStor CS Installation Guide
page 11 / 165
1-2. Hardware Components LED Status
In This Section
How to monitor the GS hardware components including enclosure, Power Supply Unit (PSU), cooling
module, controller, host interface, and drives. What actions you should take based on abnormal hardware
components status.
Contents
1-2.1 Front Panel LED
How to check the GS enclosure status by checking the combination of front panel LEDs, and the action flow
chart based on different abnormal LED combinations.
1-2.2 Power Supply Unit (PSU) LED
How to check the GS Power supply unit and cooling module status by checking the LED.
1-2.3 Controller Panel LED
How to check the GS controller panel status by checking the LED.
1-2.4 Host Interface LED
How to check the host interface status for management port, onboard and host board interfaces, and the
action you should take based on different abnormal host interface status.
1-2.5 Drive Tray LED
How to check the drive status by drive tray LED and how to replace the drive if the drive failed.
To Next Page
Loading...
