EonStor CS Installation Guide
page 96 / 165
2-1.3 Trunk Group
With the help of a trunk group, you can aggregate multiple channels as 1 to increase the total bandwidth,
thus, to provide higher performance for multiple clients and network failure tolerance.
Note: If you are trying to trunk channels with LACP, please make sure that your switch supports IEEE 802.3ad.
1. Go to Settings > Access > Channel & network.
2. Scroll down and click Mange Trunk group.
3. Click Create to create a trunk group.
4. Select the channels which you are going to trunk as a group and trunk mode.
5. Click Next and you can set up IP address.
To Next Page
Loading...
