Infortrend EonStor GS Series - 1-2.2 Power Supply Unit (PSU) LED

EonStor CS Installation Guide
page 22 / 165
Installation Guide
1-2.2 Power Supply Unit (PSU) LED
When the power supply LED shows amber light, please refer to the following table to identify the situation of
the GS. Please replace the faulty module. When you see the LED lights are amber and flashing, please
check if there is any high temperature environmental issue. Kindly contact Infortrend if you still cannot solve
the issue.
Note! GSe Pro 100/200 series didn’t include PSU LED design
 Click here if you need to replace a PSU and Cooling module for GS.
PSU LED
(for GS/GSe/GSc 1000/2000/3000/4000 series, GSa 2000 series and GSe Pro 3000 series)
Color/Status
Description
The system is connected to the power source, but the system is not turned
on.
The PSU is operating normally.
 The PSU is faulty.
 Over Voltage Protection (OVP)/ Over Power Protection (OPP)/ Over
Current Protection (OCP) is activated.
 The fan built with the PSU is faulty.
OFF
The system is not connected to the power.