Infortrend EonStor GS Series - 1-8.4 How to Replace a Memory Module (DIMM)

EonStor CS Installation Guide
page 73 / 165
Installation Guide
1-8.4 How to replace a Memory Module (DIMM)
Please refer to how to remove controller before replacing DIMM.
1. The controller comes with pre-installed DRAM module(s). You can upgrade or replace it when the
bundled module malfunctions. Please contact your reseller when there is a hardware component that
needs to be replaced.
2. To replace the memory module, you need to remove controller that contains the memory module.
3. Detach the CBM. Push down the clips to release the DRAM module from the DIMM socket, insert the
replacement DIMM carefully into the DIMM socket, with the DIMM’s notch aligned to the DIMM
socket’s notch guide.
4. Reinstall the controller back to the enclosure.