EonStor CS Installation Guide
page 45 / 165
1-4.2 How to rebuild a drive
You may see “Failed” or “Exiled” when there is a failed drive. Please replace the faulty drive if you meet any hardware
component issue. Normally, when you plug in the new drive, GS will start rebuilding. You can also manually perform
the rebuilding process via the following instructions, please note that it is necessary to clear the reserved space of an
Exiled drive before rebuilding.
When you insert a new drive to replace the faulty drive,
1. Please go to EonOne’s Settings > Storage > Pools
2. Click Pool details and scroll down to check the status of Logical Drive. When there is a failed drive, it will show
“Degraded”.
3. Click the problematic pool and click Manage logical drive.
4. Click the problematic LD, click More and click Rebuild logical drive.
5. Click Ok and the degraded LD would start to rebuild.
To Next Page
Loading...
