EonStor CS Installation Guide
page 65 / 165
1-8.2 How to replace CBM
Note! Please note that all GSe and GSe Pro series models do not include CBM to replace.
1. Please contact your reseller when there is a hardware component that needs to be replaced.
2. To replace the super capacitor. You need to remove the controller from enclosure. Loosen the screw
(A), lift its side to a 45° angle (B) and then pull to remove from the controller (C).
3. Install the replacement super capacitor to the controller and fasten the screw. Insert the controller back
to enclosure.
To Next Page
Loading...
