EonStor CS Installation Guide
page 119 / 165
Map to host
Note! It is for block-level volume only. You can perform the LUN mapping while creating the volume or
perform the LUN mapping manually.
1. Go to Settings > Storage > Volumes, select a desired volume in the list, and click Map to host button.
2. The Host LUN Mapping table will appear.
3. Click Create; the Host Mapping Configuration Window will be shown.
4. You can configure Automatic Host LUN mapping or Extended LUN mapping
Normal host LUN mapping simply presents a pool to the host links. If host links are made via an
FC switch, all servers attached to the switch (or those within the same zone) can “see” the
volume.
The extended LUN mapping binds a pool with a specific HBA port and presents the volume to the
HBA port.
To Next Page
Loading...
