EonStor CS Installation Guide
page 82 / 165
3. Press the retention lever to the left (A), then pull out the extraction handle (B).
4. Hold the extraction handle, then pull gently to remove the PSU from the system.
5. Insert the replacement PSU into the enclosure, then push it gently. When you feel a resistance, push
the module to lodge it to the backend connectors. Once lodged, the retention lever clicks back into
place.
6. Fasten the PSU to the systems using the screws that you removed in step 2.
7. Connect the power cord.
8. Turn on the system.
To Next Page
Loading...
