Innovative Technology NV11 - Page 145

NV11 Manual Set – Section 5 12
Copyright © Innovative Technology Ltd 2012 GA963-2
Action
Command Code (Hex)
Command Set
Note Dispensed at Power Up
0xCD, value/channel of note
Note Float
Note Float Removed
0xC7
Note Float Attached
0xC8
Note in Bezel Hold
0xCE, value/channel of note
Device Full
0xCF
SMART Emptying
0xB3
SMART Emptied
0xB4
Channel Disable
0xB5
* When enabled using option flag.
Notes:
Action
Comments
Command Not Known:
Returned when an invalid command is received by a
peripheral.
Wrong Number Of
Parameters:
A command was received by a peripheral, but an incorrect
number of parameters were received.
Parameter Out Of
Range:
One of the parameters sent with a command is out of
range.
Command Cannot Be
Processed:
A command sent could not be processed at that time.
Software Error:
Reported for errors in the execution of software e.g.
Divide by zero. This may also be reported if there is a
problem resulting from a failed remote firmware upgrade,
in this case the firmware upgrade should be redone
Key Not Set:
The slave is in encrypted communication mode but the
encryption keys have not been negotiated
Jammed:
Five-byte response that indicates that the validator is
jammed; this is reported until it is un-jammed or reset. It
will also become disabled.