Inovance MD520 Series - Page 96

Commissioning and Trial Run
‑95‑
Parame
ter
Code
Parameter
Name
Default Value Range Set Value
F1‑05
Rated motor
speed
Model
dependent
1 RPM to 65535 RPM
Model dependent
F1‑37 Auto‑tuning
mode
0 0: No operation
1: Static auto‑tuning on
partial parameters of
asynchronous motor
2: Dynamic auto‑tuning of
asynchronous motor
3: Static auto‑tuning on all
parameters of
asynchronous motor
4: Inertia auto‑tuning
5: Dead zone auto‑tuning
11: With‑load auto‑tuning of
synchronous motor
(excluding back EMF)
12: No‑load dynamic auto‑
tuning of synchronous
motor
13: With‑load rotary auto‑
tuning of synchronous
motor (excluding zero point
angle)
14: Auto‑tuning on gain
difference between U‑phase
and V‑phase
15: MTPA of reluctance
motor
0