Inovance MD880 Series - Page 102

5 Maintenance and Repair
- 101 -
'BOQPXFS
DBCMF
DPOOFDUPS
5PQWJFXGSPNUIF
CBDLPGUIF"$ESJWF
Figure 5-17 Disconnecting the power cable
■
Re󶍾tting the cooling fans of structures T5 to T6
Install the fan in a reverse procedure to removal. Note the following items during
installation:
1) After replacing the fan, check that the air 󶍿ow direction is upright.
"JS珞PXEJSFDUJPO
VQSJHIU
Figure 5-18 Air 󶍿ow direction: upright
2) Check that the power cables of the fan are connected securely.
3) Install the fan into the AC drive and ensure that the positioning pins are aligned.