4 HCU Control Module
- 80 -
■
Tightening torques of fasteners
The following tightening torques apply to the screws used for HCU installation.
Screw Tightening Torque
M3 0.55 N·m
4.3.2 Dimensions
ħ
Figure 4-2 Dimensions of the HCU (unit: mm)
4.3.3 Space
To install the HCU, certain space must be reserved as shown below. The HCU must be
mounted on a conductive metal surface and ensure that the entire conductive bottom
of the HCU is in good contact with the surface.
To Next Page
Loading...
