Safety Instructions
- 11 -
Repairing
◆
Equipment installation, wiring, maintenance, inspection, or parts replacement must
be performed only by professionals.
◆
Do not repair the equipment at power-on. Failure to comply will result in an electric
shock.
◆
Before inspection and repair, cut o all equipment power supplies and wait at least 15
minutes.
◆
Require repair services according to the product warranty agreement.
◆
When the equipment is faulty or damaged, require professionals to perform
troubleshooting and repair by following repair instructions and keep a repair record.
◆
Replace quick-wear parts of the equipment according to the replacement guide.
◆
Do not operate damaged equipment. Failure to comply may result in worse damage.
◆
After the equipment is replaced, perform wiring inspection and parameter settings
again.
Disposal
◆
Dispose of retired equipment by following local regulations or standards. Failure to
comply may result in property damage, personal injuries, or even death.
◆
Recycle retired equipment by following industry waste disposal standards to avoid
environmental pollution.
Safety Signs
For safe equipment operation and maintenance, comply with safety signs on the
equipment, and do not damage or remove the safety labels. The following table
describes the safety labels.
Safety Label Description
WARNING
警告
• This equipment should be serviced
by qualified personnel only.
• Locate and disconnect all energy
sources.Wait 15 minutes then
operate.
• Observe the instructions described
in the instruction manual.
• 只有专业人士才能维护。
• 维护前确保切断所有电源，15分钟后
方可操作。
• 维护前请阅读维护说明书。
This equipment must only be serviced by qualied
personnel.
Disconnect all energy sources and wait 15 minutes
before maintenance.
Read the maintenance instructions before
maintenance.
To Next Page
Loading...
Need help?
General