Inovance MD880 Series - Floor Mounting; Heat Dissipation Requirements

2 Mechanical Installation
- 32 -
1BSUJBM
WJFX
.PVOUJOH
IPMF
)PPL
1BSUJBM
WJFX
Figure 2-8 Backplate mounting of structures T2 to T9
NOTE
◆
In this mode, mount the AC drive using all mounting holes; otherwise, the
AC drive may fall o󶍽 or be damaged due to the unbalanced e󶍽ect on the
󶍾xed part during long-time running.
2.5 Floor Mounting
2.5.1 Heat Dissipation Requirements
For structures T10 to T12, only one AC drive can be installed in a cabinet. Reserve
enough clearances in the cabinet for heat dissipation. See the following guidance for
speci󶍾c model and application scenarios.