Inovance MD880 Series - Page 150

Appendix: Installation of the Sheet Metal Base and Side Entry Output Copper Busbar
- 149 -
Step Demonstration
Step 6: Install the rollers and
roller brackets to the bottom of
the sheet metal base.
1) Installing the roller brackets
Number of roller brackets: 4
Screws: Eight M8 x 20 hexagon
head SEMS screws
2) Fixing the rollers on the roller
brackets
Number of rollers: 4
Screws:
◆
Outside: M8 x 50 hex bolts
◆
Inside: M8 󶍿at washers +
spring washers + nuts
&YUFSOBM *OUFSOBM
Step 7: After the output cables
of the AC drive is connected
correctly, install the left, right,
and front ba󶎁e plates on the
sheet metal base, as shown in
the right 󶍾gure.
■
Installing the side entry output copper busbar
Step Demonstration
Step 1: Remove the
knockouts.
ЮЯа