Inovance MD880 Series - Page 43

2 Mechanical Installation
- 42 -
NOTE
◆
Remove the AC drive from the cabinet according to above steps in reverse order.
◆
Ensure the four 󶍾xed holes on the back of the AC drive are connected to the beams
securely.
◆
After push-in is complete, remove the ba󶎁e on the top of the AC drive. The ba󶎁e is
used to prevent foreign objects such as screws from falling into the air 󶍾lter when
the AC drive is mounted in the cabinet.
#B珠F
◆
Use top hoist rings to move or hoist the AC drive. If the AC drive needs to be placed
in a horizontal position, use the top hoist ring and bottom hoist hole when hoisting
the AC drive again. Ensure that the DC bus terminals su󶍽er no stress.
◆
If the AC drive needs to be placed in an upright position, prevent a stress on both
sides of the AC drive and prevent placing the AC drive on a slope because the AC
drive weighs almost 200 kg. If the inclination exceeds 5° , the AC drive may turn
over.