Connections
En-23
With u (Remote Interactive), you can use the
following special functions:
■ System On/Auto Power On
When you start playback on a component connected
via u, while the AV controller is on standby, the AV
controller will automatically turn on and select that
component as the input source.
■ Direct Change
When playback is started on a component connected
via u, the AV controller automatically selects that
component as the input source.
■ Remote Control
You can use the AV controller’s remote controller to
control your other u-capable Integra/Onkyo
components, pointing the remote controller at the AV
controller’s remote control sensor instead of the
component. You must enter the appropriate remote
control code first (➔ page 87).
Note
• Use only u cables for u connections. u cables are
supplied with Integra/Onkyo components.
• Some components have two u jacks. You can connect
either one to the AV controller. The other jack is for
connecting additional u-capable components.
• Connect only Integra/Onkyo components to u jacks.
Connecting other manufacturer’s components may cause a
malfunction.
• Some components may not support all u functions. Refer
to the manuals supplied with your Integra/Onkyo
components.
• While Zone 2/3 is on, the System On/Auto Power On and
Direct Change u functions do not work.
Connecting Integra/Onkyo RI
Components
1
Make sure that each Integra/Onkyo component
is connected with an analog audio cable
(connection
I in the hookup examples)
(➔ page 18).
2
Make the u connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape
deck, change the Input Display (➔ page 52).
LR
ANALOG
AUDIO OUT
LR
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (1/4 inch or ø
6.3 mm) to the
Phones jack.
While the headphones plug is inserted in the
Phones jack, = indicator, speaker/channel
indicator FL and FR lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the Phones
jack, the speakers are turned off. (The Zone 2/3
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, or Direct.
To Next Page
Loading...
Need help?
General