Advanced Operations
En-69
Operating procedure (➔ page 59)
■ Equalizer
*1
` Off
` Manual:
The manual setting in “Equalizer Settings”
(➔ page 65) is applied.
■ Audyssey
*1
` Off, Movie, Music
See “Audyssey” (➔ page 57).
■ Dynamic EQ
*1*2
` Off, On
See “Dynamic EQ” (➔ page 57).
■ Dynamic Volume
*1*2
` Off, Light, Medium, Heavy
See “Dynamic Volume” (➔ page 57).
Note
•“Listening Mode” is only available when the input signal
matches the setting of “Sound Program”.
• You cannot select the “Subwoofer” setting if you set it to
“No” in “Speaker Configuration”.
•“Music Optimizer” is only available when “Stereo
Source 1”, “Stereo Source 2” or “Stereo Source 3” is
selected.
• When “Audyssey Quick Start” has been used for
measurement, the “Audyssey”setting cannot be selected.
*1
This setting cannot be used when the “Listening Mode”
setting is set to “Direct”.
*2
To enable this setting, you must first perform the Room
Correction and Speaker Setup.
Items can be set individually for each input selector.
Press the input selector buttons to select an input
source.
Audyssey
®
The tone for each speaker is set automatically by
Audyssey MultEQ
®
XT32 Room Correction and
Speaker Setup. To enable the following settings, you
must first perform the Room Correction and Speaker
Setup (➔ page 27).
• These technologies cannot be used when a pair of
headphones is connected.
■ Audyssey
` Off
` Movie:
Select this setting for movie material.
The Audyssey indicator will light.
` Music:
Select this setting for music material.
The Audyssey indicator will light.
Note
• When “Audyssey Quick Start” has been used for
measurement, “Audyssey” cannot be selected.
■ Dynamic EQ
` Off
` On:
Audyssey Dynamic EQ
®
becomes active.
The Dynamic EQ indicator will light.
With Audyssey Dynamic EQ, you can enjoy great
sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of
deteriorating sound quality as volume is decreased by
taking into account human perception and room
acoustics. It does so by selecting the correct
frequency response and surround volume levels
moment-by-moment so that the content sounds the
way it was created at any volume level — not just at
reference level.
■ Reference Level
Audyssey Dynamic EQ Reference Level Offset
` 0dB:
This should be selected for movie contents.
` 5dB:
Select this setting for content that has a very
wide dynamic range, such as classical music.
` 10dB:
Select this setting for jazz or other music that
has a wider dynamic range. This setting should
also be selected for TV content as that is usually
mixed at 10 dB below film reference.
` 15dB:
Select this setting for pop/rock music or other
program material that is mixed at very high
listening levels and has a compressed dynamic
range.
Movies are mixed in rooms calibrated for film
reference. To achieve the same reference level in a
home theater system each speaker level must be
adjusted so that –30 dBFS band-limited (500 Hz to
2000 Hz) pink noise produces 75 dB sound pressure
level at the listening position. A home theater system
automatically calibrated by Audyssey MultEQ XT32
4. Source Setup
To Next Page
Loading...
Need help?
General