Advanced Operations
En-81
Operating procedure (➔ page 59)
Remote ID
■ Remote ID
` 1
, 2, or 3
When several Integra/Onkyo components are used in
the same room, their remote ID codes may overlap.
To differentiate the AV controller from other
components, you can change its remote ID from “1”,
to “2” or “3”.
Note
• If you do change the AV controller’s remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won’t be able to control it with the remote
controller.
Changing the remote controller’s ID
Remote Mode Setup
See “Looking up for Remote Control Codes”
(➔ page 86).
With this preference, you can protect your settings by
locking the setup menus.
■ Setup
` Locked
` Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
8. Remote Controller Setup
1
While holding down Receiver, press and hold
down Q Setup until the Receiver lights (about
3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
Receiver flashes twice.
9. Lock Setup
To Next Page
Loading...
Need help?
General