Playback
En-51
You can display various information about the current
input source as follows.
The following information can be typically displayed.
*1
If the input signal is digital, the signal format is displayed.
With the sleep timer, you can set the AV controller to
turn off automatically after a specified period.
You can adjust the brightness of the AV controller’s
display.
Displaying Source Information
1
Press Receiver once followed by Display
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use Display on the AV
controller.
Sampling
frequency
Input source
Signal format
*1
Listening mode
Input signal
resolution
Output resolution
Using the Sleep Timer
1
Press Receiver once followed by Sleep
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV controller’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
Tip
• If you need to cancel the sleep timer, press Sleep
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV controller
sleeps, press Sleep. Note that if you press again on
Sleep as the time being displayed is 10 minutes or
less, the sleep timer will go off.
Setting the Display Brightness
1
Press Receiver once followed by Dimmer
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• Alternatively, you can use Dimmer on the AV
controller.
To Next Page
Loading...
Need help?
General