Advanced Operations
En-56
Operating procedure (➔ page 55)
*2
When HDMI IN 1/2/3/AUX Input is displayed on the main
preview, HDMI IN 4 is also displayed on the preview
thumbnails.
*3
• The video preview is not displayed when the “Zone 2
Monitor Out” setting is set to “HDBaseT(TM)”
(➔ page 60).
• The video of the currently-selected input is displayed on
the main screen, not on a preview thumbnail.
*4
“Dynamic EQ” and “Dynamic Volume” cannot be
selected when any of the THX listening modes is
selected, with “Loudness Plus” set to “On” or “Preserve
THX Settings” set to “Yes” (➔ page 65).
*5
• When the “Monitor Out” setting is set to
“HDBaseT(TM)”, “Video” cannot be selected
(➔ page 60).
• This setting cannot be used with the “NET”, “USB” and
“BLUETOOTH” input selectors.
*6
Only when you have selected “Custom” in the “Picture
Mode” (➔ page 72), pressing Enter allows you to adjust
the following items via the Quick Setup: “Brightness”,
“Contrast”, “Hue” and “Saturation”. Press Return to
return to the “Picture Mode” setting.
*7
Depending on the input source and listening mode, not
all channels shown here output the sound.
*8
• This setting is not available in either of the following
cases:
– The “Audio TV Out (HDMI)” setting is set to “On”
(➔ page 78) or “Audio TV Out (HDBaseT(TM))”
setting is set to “On” (➔ page 78) and you’re listening
through your TV speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 77) and
you’re listening through your TV speakers.
Explanatory Notes
a Setting target
b Setting options (default setting underlined)
You can change various audio settings from the
Quick Setup (➔ page 55).
Note
• These settings are not available in either of the following
cases:
– The “Audio TV Out (HDMI)” setting is set to “On”
(➔ page 78) or “Audio TV Out (HDBaseT(TM))” setting
is set to “On” (➔ page 78) and you’re listening through
your TV speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 77) and
you’re listening through your TV speakers.
Sound Program
■ Sound Program
` Stereo Source 1, Stereo Source 2, Stereo
Source 3, Multich Source 1, Multich Source 2,
Multich Source 3
` Off
With this setting, you can select the combination of
settings that you registered in “Sound Program Edit”
(➔ page 68).
Note
• If the input selector is changed, the “Sound Program”
setting is switched back to “Off”.
Tone Control
■ Bass
` –10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds
output from the front speakers.
■ Treble
` –10dB to 0dB
to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds
output from the front speakers.
You can adjust the bass and treble for the front
speakers, except when the Direct or THX listening
mode is selected.
Operating on the AV controller
■ Phase Matching Bass
` Off
` On
a
b
Using the Audio Settings of Quick
Setup
1
Press Tone repeatedly to select either “Bass”
or “Treble”.
2
Use – and + to adjust.
To Next Page
Loading...
Need help?
General