En-24
Turning On & Basic Operations
Turning On/Off the AV
Controller
Note
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV controller may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem, plug the
AV controller into a different branch circuit.
• Do not use a power cord other than the one supplied with
the AV controller. The supplied power cord is designed
exclusively for use with the AV controller and should not be
used with any other equipment.
• Never disconnect the power cord from the AV controller
while the other end is still plugged into a wall outlet. Doing
so may cause an electric shock. Always disconnect the
power cord from the wall outlet first, and then the AV
controller.
■ Smooth Operation in a Few Easy Steps
(Initial Setup)
To ensure smooth operation, here’s a few easy steps
to help you configure the AV controller before you use
it for the very first time. These settings only need to
be made once. See “Initial Setup” for details
(➔ page 25).
Tip
• The Hybrid Standby indicator may light depending on the
status of settings (➔ page 25).
• For details on power management settings, see “Auto
Standby” (➔ page 79).
• If the HDMI Through setting is not set in standby mode, an
MHL-enabled mobile device cannot be charged even if it is
connected.
Turning On & Basic
Operations
Connecting the Power Cord
1
Connect the supplied power cord to the AV
controller’s AC INLET.
2
Plug the power cord into an AC wall outlet.
To AC wall outlet
Turning On
1
Press 8On/Standby on the front panel.
or
Press Receiver followed by 8Receiver on the
remote controller.
The AV controller comes on and its display lights.
Turning Off
1
Press 8On/Standby on the front panel.
or
Press Receiver followed by 8Receiver on the
remote controller.
The AV controller will enter standby mode. To
prevent any loud surprises when you turn on the
AV controller, always turn down the volume
before you turn it off.
To Next Page
Loading...
Need help?
General