EasyManuals Logo

Integra DHC-60.5 User Manual

Integra DHC-60.5
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
Advanced Operations
En-85
To control the AV controller with the remote controller
while you’re in Zone, you’ll need a commercially
available multiroom remote control kit for each zone.
Multiroom kits are made by Niles and Xantech.
These kits can also be used when there isn’t a clear
line of sight to the AV controller’s remote sensor, such
as when it’s installed inside a cabinet.
Using a Multiroom Kit with Zone
In this setup, the IR receiver in Zone picks up the
infrared signals from the remote controller and feeds
them through to the AV controller in the main room
via the connecting block.
The miniplug cable from the connecting block should
be connected to the AV controller’s IR IN A or B jack,
as shown below. The IR IN A and B jacks are
identical. Up to two IR receivers can be connected.
Using a Multiroom Kit with a Cabinet
In this setup, the IR receiver picks up the infrared
signals from the remote controller and feeds them to
the AV controller located in the cabinet via the
connecting block.
Using a Multiroom Kit with Other
Components
In this setup, an IR emitter is connected to the AV
controller’s IR OUT jack and placed in front of the
other component’s remote control sensor. Infrared
signals received at the AV controller’s IR IN A or B
jack are fed through to the other component via the IR
emitter. Signals picked up by the AV controller’s
remote control sensor are not output.
The IR emitter should be connected to the AV
controller’s IR OUT jack, as shown below.
Using the Remote Controller in
Zone and Multiroom Control Kits
IR IN
A or B
Connecting
block
Remote controller
IR
receiver
Main room Zone
Signal flow
From the connecting block
Miniplug cable
AV controller
Signal flow
IR IN
A or B
Connecting
block
Remote controller
IR
receiver
Inside
cabinet
Signal flow
IR IN
A or B
IR OUT
Connecting
block
IR
receiver
Remote controller
Signal flow
IR Emitter
Other component
AV controller
Remote control sensor
Other component
Emitter
Signal flow
Miniplug
Miniplug cable
AV controller
From the connecting block
IR Emitter

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Integra DHC-60.5 and is the answer not in the manual?

Integra DHC-60.5 Specifications

General IconGeneral
BrandIntegra
ModelDHC-60.5
CategoryMedia Player
LanguageEnglish