Playback
En-49
Note
*1
Based on the audio channel signal contained in the source, the corresponding speakers
will output the sound.
*2
The AV controller can input the DSD signal from HDMI IN. Depending on the player,
setting the output on the player side to PCM might bring better sound.
*3
For the Blu-ray Discs, Dolby Digital is used in a 3.1/5.1-channel speaker system.
*4
DTS is used depending on the configuration of the AV controller.
*5
If there are no surround back speakers, DTS is used.
*6
If there are no surround back speakers, Dolby Pro Logic II is used.
*7
DTS Neo:X cannot be selected in the case of 192 kHz input signals.
*8
This listening mode can be selected only when all the following conditions are satisfied:
– Center speaker is connected.
– Either the front high or front wide speakers are connected.
*9
This type of speaker layout is available only when the input source is stereo sound.
• THX Surround EX
This mode expands 5.1-channel
sources for 6.1/7.1- channel playback.
It’s especially suited to Dolby Digital EX
sources. THX Surround EX, also
known as Dolby Digital Surround EX, is
a joint development between Dolby
Laboratories and THX Ltd.
D
H
V
Listening Mode Description Input
Source
Speaker
Layout
THX Su r r EX
To Next Page
Loading...