Intellian v100GX - Upgrade Procedures; Firmware Upgrade Status Page; Upgrade Process Status Page

v100 – Marine Satellite Communication System
128
Upgrade procedures:
1. Select the upgrade package le. In Auto Upgrade mode, check new rmware le
automatically by clicking Check button.
2. Click on “Start Upload” button to transfer the Firmware package le (“*.fwp”) to E2S
(Ethernet to serial) module. In Auto Upgrade mode, click "Upgrade" button once new
rmware le is detected.
3. After the package le is transferred, it’ll show “upgrade from vx.xx Version to vx.xx
Version”. Enable the check box to select the rmware le that you wish to upgrade.
To select all rmware les, click Select All Firmwares.
4. Click on “Start Upgrade” button.
Firmware upgrade
status page
Upgrade process
status page
5. It'll display information about the upgrade process status on full screen.
6. If the rmware is successfully upgraded, it'll display "The rmware update is
completed."
7. Click on "Back to main page" to go out of the screen.
To verify the upgraded rmware version, go to Dash Board > Software Information.