134
4
Wi-Fi Access
Point
Conguration
- SSID : The SSID is the network name shared among all devices in
a wireless network. The SSID must be identical for all devices in the
wireless network. It is case-sensitive and must not exceed 32 alpha-
numeric characters, which may be any keyboard character. Make
sure this setting is the same for all devices in your wireless network.
- Channel : Select an appropriate channel from the list provided to
correspond with your network settings. All devices in your wireless
network must use the same channel in order to function correctly.
Try to avoid conicts with other wireless networks by choosing a
channel where the upper and lower three channels are not in use.
- Authentication Type : Module supports an authentication mode
that the 802.11 device uses when it authenticates and associates
with an access point or IBSS cell.
- Password : WiFi access password.
- Max Stations : Setting max stations.
5
Network Service
Conguration
- Telnet Service : Enable or disable telnet login support.
- HTTPS Port : HTTPS port number.
6
Sys Log
Conguration
Set the system log conguration.
Antenna sends log messages according to emergency level.
Enabling this function sends the message to your management
server.
- Management Server : Sys log function enable/disable
- Server IP : Management server IP address
- UDP Port : Management port
- Message Type : Select message type (Intellian message level)
to send to management server (Lower number indicates higher
emergency).
- Sys log Target Level : If you select this target level, the management
server receives log message equal to or less than this level.
7
Browser
Conguration
Setting refresh rate and refresh disable time.
- Refresh Rate : Set the browser refresh rate
(Default 1 seconds. Range 1~99).
- Refresh Disable Time : Set the browser idle time-out
(Default:9 minutes. Range 0~9). To use this function, check the
check box.
To Next Page
Loading...
Need help?
General
