Interacoustics VisualEyes 515 - General Technical Specifications; Computer Specifications; Relevant Standards; Operation and Storage Specifications

D-0126445-A – 2020/08
VisualEyes™ 515/525 Instructions for Use - EN Page 36
6 General technical specifications
6.1 Computer specifications
Hardware and software
Desktop PC: One PCI Express card available (FireWire® systems only).
USB port required (expanded by USB hub)
Intel i5 processor 2.5 GHz or better, and not older than 5th generation. Minimum 4 cores (4 threads).
Minimum 8 GB RAM or more.
Hard drive with min. 250 GB space.
Minimum display of 1366x768 (Higher resolution recommended).
Touch monitor or laptop with touch screen is highly recommended though not required.
Operating systems supported:
Windows® 7 64-bit.
Using operating systems where Microsoft have discontinued software and security support will
increase the risk for viruses and malware, which may result in breakdowns, data loss and data
theft and misuse. Interacoustics A/S cannot be held liable for your data. Some Interacoustics
A/S products support or may work with operating systems unsupported by Microsoft.
Interacoustics A/S recommends you to always use Microsoft supported operating systems that
are kept fully security updated.
Windows® 8.1 64-bit.
Windows® 10 64-bit.
6.2 Standards
IEC 60601-1: 2012
Medical electrical equipment – Part 1: General requirements for basic safety and
essential performance
IEC 60601-1-2: 2014
Medical electrical equipment – Part 1-2: General requirements for basic safety
and essential performance – Collateral standard: Electromagnetic compatibility
– Requirements and tests
ANSI S3.45
Performance standard
6.3 Operation and storage specifications
Operation environment:
Temperature: 15° – 35° C (59°F - 95°F)
Relative Humidity: 30 – 90%
Transport:
Transport Temperature: -20° – 50° C (-4°F - 122°F)
Rel. Humidity: 30% – 80% Non-Condensing, Keep Dry
Storage:
Temperature: 0° – 50° C (32°F - 122°F)
Systems can operate on 100 to 240 VAC at frequencies of 50/60 Hz. A grounded plug can be used for the
intended voltage, frequency and socket style used in the customer’s region. Only power cables supplied
should be used with the equipment. When used with the rotary chair, an isolation transformer is used to
supply power to the components from power mains.