ZeroWire Installation Manual 9
Add Your Sensors
Unpack Sensors
These instructions are for general information only. Please refer to the manual included
with each sensor for further details.
1. Remove the sensor from packaging.
2. Remove a battery cover of the sensor.
3. Install batteries taking care to insert them correctly. Batteries inserted with reverse
polarity may damage the sensor.
Learning Sensors into ZeroWire
Example: Add a PIR motion detector to ZeroWire and assign it as sensor 1.
1.
Select Sensor Configuration.
2.
Enter your Installer code.
3.
Select 1 to add sensor.
4.
Activate the sensor learn-in sequence (see specific
wireless sensor manual for instructions).
ZeroWire will announce that the sensor or keyfob is
detected.
5.
Assign the sensor as sensor number 1, or just press
Enter to automatically assign a number. Press 1-6 for
the sensor group.
6.
Exit from the menu.
Install Sensor in Home
1. Replace battery cover.
2. Install sensor in a suitable location. Here are some tips:
• Wireless sensors feature low power transmission to maximize battery life. This means
you should place the ZeroWire in a central location and install sensors as close to the
ZeroWire as possible.
• Signals from each sensor will reduce in strength as they pass through different building
materials with brick and concrete absorbing more of the signal.
• Keep sensors away from household appliances and metal surfaces (e.g. refrigerator,
TV, washing machine, garage door). Metal surfaces will reflect the signal away.
MENU MENU MENU
ENTER 1
PRESS DEVICE BUTTON
1
ENTER
YOUR 4 OR 6 DIGIT INSTALLER CODE
5 MENU
To Next Page
Loading...
Need help?
General
