ZeroWire Installation Manual 45
DLX900 Software
DLX900 is a fully featured management tool for control rooms and security professionals.
Compatible with Microsoft Windows 7 and 8, this is available to download from our website
(to be completed).
In order for DLX900 to connect to a ZeroWire panel you will need:
• the IP address of the ZeroWire (or use the Discover feature for LAN connections)
• to know the Download Access Code (see Troubleshooting section on page 46) and
• if Always Allow DLX900 is enabled then you will be allowed to connect,
if Always Allow DLX900 is disabled then you must first put the ZeroWire into program
mode, this can be changed in Settings-Network.
1. Install and launch DLX900 software.
2. Create a new customer and select ZeroWire for the Panel.
3. Enter the TCP/IP address of the ZeroWire, Click Save.
4. Go to Communicator – Remote Access.
To Next Page
Loading...
Need help?
General
