EasyManuals Logo

Interlogix ZeroWire Installation Manual

Interlogix ZeroWire
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
ZeroWire Installation Manual 49
Z-Wave messages
"Unavailable - Failed Device Function in progress" - An attempt was made to enter an add/
remove mode when the failed device mode is active.
"Unavailable - Add mode active" - An attempt was made to enter an add/remove mode when
the add mode is active.
"Unavailable - Remove mode active" - An attempt was made to enter an add/remove mode
when the remove mode is active.
"Unavailable - Resetting Network" - An attempt was made to enter an add/remove mode when
the resetting mode is active.
"Unavailable - Backing Up Network" - An attempt was made to enter an add/remove mode
when the backup mode is active.
"Unavailable - Restoring Network" - An attempt was made to enter an add/remove mode when
the restore mode is active.
"Busy, Try Again Momentarily" - This message is received when the Z-Wave module is
attempting to execute a command and a new command was submitted.
"Not primary controller" - An attempt was made to perform device functions when not a primary
controller.
"Device Not found in failed list" - An attempt was made to remove a failed device that is now
responding.
"Remove Device failed - already in process" - An attempt was made to enter a remove mode
when the remove mode is active.
"Replace Device failed - already in process" - An attempt was made to enter a replace mode
when the replace mode is active.
"Remove Failed" - An attempt to remove a device from the network has failed.
"Replace Failed"- An attempt to replace a device from the network has failed.
"Function timed out or canceled" Add/Remove/Replace function timed out.
"Unavailable, Try Again Later" - This message is received when the Z-Wave module is still
initializing.
"Command Failed" - A Z-Wave command has failed.
"You must press Select to choose a set point" - A set point change was attempted without
selecting a set point to change.
"There are no Failed Devices" - Displayed in the failed device dialog when no failed devices
detected.

Other manuals for Interlogix ZeroWire

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Interlogix ZeroWire and is the answer not in the manual?

Interlogix ZeroWire Specifications

General IconGeneral
BrandInterlogix
ModelZeroWire
CategorySecurity System
LanguageEnglish

Related product manuals