Chapter 3 — Configuring the Computer
98 CN3 Series Mobile Computer User’s Manual
Follow these steps to enable WEP encryption:
a Set Authentication to Open if WEP keys are not required
or to Shared when WEP keys are required for association.
b Set Data Encryption to WEP.
c To change the network key, clear The key is
automatically provided check box, enter the new
Network key, and then select the appropriate Key index.
Follow these steps to enable WPA authentication:
a Set Authentication to WPA.
b Set Data Encryption to either WEP or TKIP.
Follow these steps to enable WPA authentication using a
preshared key:
a Set Authentication to WPA-PSK.
b Set Data Encryption to either WEP or TKIP.
c Enter the new Network key.
Follow these steps to enable WPA2 authentication:
a Set Authentication to WPA2.
b Set Data Encryption to AES or TKIP.
c Enter the new Network key.
Follow these steps to enable WPA2 authentication using a
preshared key:
a Set Authentication to WPA2-PSK.
b Set Data Encryption to AES or TKIP.
c Enter the new Network key.
7 Tap Next.
8 From the EAP type list, select either PEAP or Smart Card or
Certificate and then tap Finish.
9 From the Networks to access list, select All Available, Only
access points, or Only computer-to-computer.
To Next Page
Loading...
