Intermec PM4I - Page 103

Chapter 4 — Troubleshooting and Maintaining the Printer
PM4i Mid-Range Printer User’s Manual 89
RtW off by
application
This condition is set by the Fingerprint SYSHEALTH
command. For more information, see the Intermec
Fingerprint Command Reference Manual.
Off
Application
break
If you perform a user break by pressing S - P to
stop an application from running, or if a runtime
error occurs, the Intermec Ready-to-Work indicator
turns off. You can turn the indicator on by changing
to Direct Protocol or running an application.
But, if the application handles the break (ON
BREAK) or runtime error (ON ERROR GOTO), the
Intermec Ready-to-Work indicator is not affected,
and the application sets the status. For more
information, see the Intermec Fingerprint Command
Reference Manual.
Off
Printhead not
found
Printhead not found. Off
Rebooted The printer has been rebooted. Off
Initializing The printer is initializing. Off
Printer crash Printer crash. In most instances, when the printer
crashes, the screen is reset which causes the Intermec
Ready-to-Work indicator to turn off.
Off
Printer turned
off
The printer is off. Off
Maintenance The printer is upgrading its firmware. Wait for the
printer to complete this task.
Off
Power supply
Over
temperature
The power supply is overheated and needs to cool
down.
Off 1718
Printhead too
hot
The printhead is overheated and needs to cool down.
You need to resend your print job.
Off 1088
Fingerprint Error Messages (continued)
Message Description
Ready-to-Work
Indicator Status
Error
Number