Intermec PM4I - Page 104

Chapter 4 — Troubleshooting and Maintaining the Printer
90 PM4i Mid-Range Printer User’s Manual
IPL Error Messages
Message Description
Ready-to-Work
Indicator Status
Error
Number
Paper Out The printer is out of paper. Load a new roll of media.
For help, see “Loading Media” on page 9.
Blinking 1005
Ribbon Out The printer is out of transfer ribbon. Load a new roll
of ribbon. For helps, see “Loading Ribbon” on
page 31.
Blinking 1031
Ribbon Fitted This is not an error condition. This message briefly
appears after a new roll of transfer ribbon is
installed.
Blinking
Printhead Up The printhead is lifted. Lower the printhead. Blinking 1027
Open & Shut
Cutter
Cutter error 1. Open and shut the cutter. Blinking 1058
Open & Shut
Cutter
Cutter error 2. Open and shut the cutter. Blinking 1022
Open & Shut
Cutter
Cutter error 3. Open and shut the cutter. Blinking 1059
Paper Fault LSS too high. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see “Loading Media” on page 9.
Blinking 1701
Paper Fault LSS too low. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see “Loading Media” on page 9.
Blinking
Paper Fault The printer did not perform a test feed before it
printed out test labels. Performing a test feed
calibrates the sensor. To perform a test feed Press the
B button.
Blinking
Press Feed Press the F button to resume. Blinking
Paused This is not an error condition. This message appears
when the print job is paused.
Blinking
Setup mode entered. Off
IP link error. No network connection. Blinking