Intermec SF51 User Manual

Chapter 1 — Using the SF51
8 SF51 Cordless Scanner User’s Guide
You can change the beep volume for your needs and
environment. You can set the beep volume to Low (quiet),
Medium (loud), and High (very loud - default).
Note: To turn off the beeper, you set the Beep
Duration to 0. Turning off the beeper does not
affect the beeps associated with Bluetooth
Connect/Disconnect or Bluetooth Device Page.
You can also change the beeper duration and beeper frequency.
For more information about the beeper commands, see
Chapter 4, “Configuration Command Reference.”
Using Vibrate Alert
You can configure the SF51 to vibrate when a bar code is
successfully decoded. This feature can be useful in these
situations:
• You are in a noisy environment, such as a busy warehouse,
where it can be difficult to hear the beep.
• You are working in a quiet environment, such as a library,
where you do not want to make a lot of noise.
To turn on vibrate alert
• Scan this bar code:
Turn On Vibrate Alert
\60\03\10\48\00\02\40
To turn off vibrate alert
• Scan this bar code:
Turn Off Vibrate Alert
\60\03\10\48\00\00\00

Intermec SF51 Specifications

Capacity and Output

maximum output voltage	4.1 V
mean output voltage	3.7 V
capacity	2400 mAh

Temperature and Humidity

operating temperature range	-20°C to 50°C
charging temperature range	0°C to 35°C
storage temperature range	-20°C to 60°C
recommended storage temperature	21°C
humidity range	0 to 95% non-condensing

Weight and Dimensions

length	73 mm
diameter	19 mm
weight	55 g