Intermec SF51 - Collecting Data With Your SF51

Chapter 1 — Using the SF51
10 SF51 Cordless Scanner User’s Guide
If you are scanning a 2D bar code, pass the beam over the bar
code label in a steady sweeping motion. The scanner emits a
crackle sound.
*INTERMEC*
Scanning With the SF51: There are two different ways to comfortably
hold the SF51.
When the SF51 successfully reads a bar code label, you hear a
single beep and the status light briefly turns green. If Vibrate
Alert is enabled, the SF51 briefly vibrates.
5 Release the Scan button.
Collecting Data With Your SF51
After you connect your SF51 to your host device, you are ready
to start collecting data. The method you use depends on whether
you are using:
• an Intermec computer.
• a host PC.
• the SF51 as a keyboard wedge.