Intermec SF51 User Manual

Chapter 4 — Configuration Command Reference
36 SF51 Cordless Scanner User’s Guide
Using Configuration Commands
A configuration command changes the way the SF51 operates.
For example, you can change the Beep Volume and make the
SF51 beeper very quiet for a quiet environment.
You can configure the SF51:
• using EasySet online. Send commands to your SF51 from
your PC using EasySet. For help, see the procedure “To
configure the SF51 online with EasySet” on page 14.
• using EasySet offline. Send commands to a bar code setup
sheet. Then, scan the bar codes onscreen with your SF51, or
print the setup sheet and scan the bar codes. You do not need
a Bluetooth connection to use this method. For help, see the
procedure “To configure the SF51 offline with EasySet” on
page 15.
• from your Intermec computer. Send commands to your SF51
from your Intermec computer using Intermec Settings. For
help, see the procedure “To configure the SF51 from your
Intermec computer” on page 16.
For a list of all the commands and their default values as they are
organized in EasySet, see the next section, “Configuration
Commands By Function.”
For descriptions of each command organized alphabetically, see
“SF51 Configuration Commands” on page 40.

Intermec SF51 Specifications

Capacity and Output

maximum output voltage	4.1 V
mean output voltage	3.7 V
capacity	2400 mAh

Temperature and Humidity

operating temperature range	-20°C to 50°C
charging temperature range	0°C to 35°C
storage temperature range	-20°C to 60°C
recommended storage temperature	21°C
humidity range	0 to 95% non-condensing

Weight and Dimensions

length	73 mm
diameter	19 mm
weight	55 g