Intermec SF51 - Trigger Timeout; Turn off after Good Read

Chapter 4 — Configuration Command Reference
SF51 Cordless Scanner User’s Guide 53
Trigger Mode Options (continued)
Mode Description
Autostand Autostand mode allows you to switch between
level mode and flashing mode. The first time you
press the Scan button, the scanner beam turns on
and the scanner is in flashing mode. You switch to
level mode by pressing the Scan button again. If
the scanner is idle and the Trigger Timeout
period is reached, the scanner returns to flashing
mode.
Aim Aim triggering allows you to turn on the scanner
and aim the red scanner beam without causing a
decode. Releasing the Scan button enables the
decode.
Note: EasySet contains a folder, predefined modes,
in Operating settings > trigger activation. The
commands in this folder are currently not supported
on the SF51.
Trigger Timeout
Set the Trigger Timeout for the Trigger Mode command. You
can set Trigger Timeout from 1 to 4095 seconds.
Turn Off After Good Read
Sets how the SF51 operates in level and pulse trigger modes.
Trigger
Mode
Turn Off After
Good Read SF51 Behavior
Level Enabled The SF51 turns off after it
successfully reads a bar code.
Level Disabled The SF51 stays on until you release
the Scan button.
Pulse Enabled The SF51 turns off after it
successfully reads a bar code.
Pulse Disabled The SF51 stays on until the Trigger
Timeout period is reached.