Intermec SF51 User Manual

Chapter 4 — Configuration Command Reference
SF51 Cordless Scanner User’s Guide 41
Beep Volume
Adjusts the volume of the beeps. You can set Beep Volume to
Low, Medium, or High.
Note: To turn off the beeper, you set the Beep
Duration to 0. Turning off the beeper does not
affect the beeps associated with Bluetooth
Connect/Disconnect or Bluetooth Device Page.
Use Beep Volume in combination with Beep Frequency and
Good Read Beep Duration to define beeps according to operator
preference and work environment.
Bluetooth Connect/Disconnect
Connects or disconnects Bluetooth communications between
the SF51 and host computer if you are using Serial Port Profile
(SPP).
To connect to a host computer, enter the Bluetooth address
of the computer and scan the bar code with the SF51. To
disconnect, scan the disconnect bar code.
Bluetooth Device Name
Sets the name of the scanner. If the scanner is in a discoverable
state, its Bluetooth device name is available to host computers
during device discovery.
Bluetooth Device Page
If your SF51 is within Bluetooth communication range of your
host PC, you can send this command from EasySet to locate the
SF51. For help, see “Locating the SF51” on page 32.

Intermec SF51 Specifications

Capacity and Output

maximum output voltage	4.1 V
mean output voltage	3.7 V
capacity	2400 mAh

Temperature and Humidity

operating temperature range	-20°C to 50°C
charging temperature range	0°C to 35°C
storage temperature range	-20°C to 60°C
recommended storage temperature	21°C
humidity range	0 to 95% non-condensing

Weight and Dimensions

length	73 mm
diameter	19 mm
weight	55 g