Interroll RollerDrive EC5000 AI - Start-up and operation; Warning notices for start-up and operation; Start-up

46 of 54
Version 2.4 (03/2020) Online
Translation of the original operating manual
Start-up and operation
6 Start-up and operation
6.1 Warning notices for start-up and operation
WARNING
Risk of crushing and potential hazards from rotating parts due to uncontrolled start-up of the RollerDrive.
¾ Do not reach between RollerDrive and drive media with your ngers.
¾ Do not remove the protective equipment.
¾ Keep ngers, hair and loose clothing away from the RollerDrive.
NOTE
Possible damage to the RollerDrive through induction.
¾ Do not slide any objects over the roller conveyor by hand.
¾ Do not turn the RollerDrive by hand.
6.2 Start-up
Check before the initial start-up
¾ Ensure that there are no points of contact between objects and rotating/moving parts.
¾ Ensure that all screws have been tightened according to the specications.
¾ Ensure that no additional hazards are formed through the interfaces to other components.
¾ Ensure that the wiring conforms to specications and legal provisions.
¾ Ensure that no persons are in the hazardous areas by the conveyor system.
¾ Check all protective equipment.
Information on start-up can be found in the operating manual for the Interroll control system or motor
control system that is used.