Interroll RollerDrive EC5000 AI - Decommissioning and disposal; Decommissioning; Disposal

50 of 54
Version 2.4 (03/2020) Online
Translation of the original operating manual
Decommissioning and disposal
9 Decommissioning and disposal
CAUTION
Risk of injury from following incorrect procedure.
¾ Decommissioning must only be carried out by authorised, qualied personnel.
¾ Only decommission the RollerDrive when the system has been disconnected from the power supply.
¾ Switch o the power to the RollerDrive and ensure that it cannot be unintentionally switched on again.
9.1 Decommissioning
¾ Disconnect the RollerDrive cable from the control system.
¾ Remove the outer nut from the motor shaft.
¾ If the RollerDrive is tted with an internal thread shaft pin, remove the screw on the shaft.
¾ Remove the RollerDrive from the side prole.
9.2 Disposal
The operating company is responsible for disposing of the RollerDrive according to correct procedure. In
doing so, the industry-specic and local provisions for disposing of the RollerDrive and its packaging must
be observed.