Version 2.4 (03/2020) Online
Translation of the original operating manual 7 of 54
About this document
1 About this document
1.1 Information about this operating manual
This operating manual covers the following Interroll motor rollers:
• RollerDrive EC5000 AI with analogue interface, 24 V DC and 48 V DC
• RollerDrive EC5000 BI with digital CANopen bus interface, 24 V DC and 48 V DC
in three dierent power levels (see „Product description“ on page 16).
In the course of this manual, the term "RollerDrive" will sometimes be used, or alternatively the type designation
"EC5000".
The operating manual is a component of the product and contains important advice and information regarding the
dierent operating phases of the RollerDrive. It describes the RollerDrive at the time of shipping from Interroll.
The currently applicable version of this operating manual can be found online at: www.interroll.com/support/
All the information and advice in this operating manual has been compiled with respect to applicable standards and
regulations as well as the current state of the art.
For special versions, in addition to this operating manual, particular contractual arrangements and technical
documents apply.
¾ To ensure safe and faultless operation and to full any warranty claims that may apply, read this operating
manual rst and observe its instructions.
¾ Keep this operating manual within close reach of the RollerDrive.
¾ Pass this operating manual onto every subsequent owner or user.
The manufacturer assumes no liability for damage and malfunctions that occur as a result of non-
compliance with this operating manual.
Should you still have any unanswered questions after reading this operating manual, please contact Interroll
customer service. Contact details for your region can be found online at www.interroll.com/contact/
Please direct any comments and suggestions regarding our operating manuals to manuals@interroll.com
To Next Page
Loading...
Need help?
General
