User’s Manual of netMod Network Termination Unit
0 Disable Total and Last call’s charging counters of analogue adapter,
ab1.
0
1 1 Enable Total and Last call’s charging counters of analogue adapter,
ab1.
0 0 Disable Total and Last call’s charging counters of analogue adapter,
ab2.
1
2 2 Enable Total and Last call’s charging counters of analogue adapter,
ab2.
0 0 Disable Total and Last call’s charging counters of data port. 2
4 4 Enable Total and Last call’s charging counters of data port.
0 0 Disable the metering pulse of analogue adapter, ab1. 5
32 32 Enable the metering pulse of analogue adapter, ab1.
0 0 Disable the metering pulse of analogue adapter, ab2.
6
64 40 Enable the metering pulse of analogue adapter, ab2.
S90= 0 –
63
0-3F Set TEI (Terminal Endpoint Identifier)
S91= 0 -
255
0 -
FF
Set LCN (Logical Channel Number)
bit dec hex Supplementary Services Protocol
0* 0* Functional Protocol is enabled. 0
1 1 Keypad Protocol is enabled.
0 0 3.1 Khz Audio Bearer capability
S100=
1
1 1 Speech Bearer capability
bit dec hex CID transmission method
0* 0* CID FSK pattern is transmitted during ringing between the 1
st
and 2
nd
ring.
S101=
0
1 1 CID FSK pattern is transmitted prior to ringing.
S102= 1 1 Enable BAP (Bandwidth Allocation Protocol) for PPP links
Bit Bin
0 Do not wait for restart
01 Wait for 1 second
10 Wait for 5 seconds
0-1
11 Wait for 20 seconds
2 1 PAD connection, makes a X.28 PAD call when is set. That means to
send a X.29 PAD protocol ID (01000000) as call user data in the call
request packet.
Selects PAD initial profile
0 Default profile is simple X.28 profile.
3
1 Default profile is transparent X.28 profile.
4 Configure the X.25 link to be a PVC
5 Sends a restart request when Layer 2 is up.
6 When is set you can use a PAD interface, instead of an AT interface.
0 Default (no semi – permanent connection)
S103=
7
1 Set it if your connection type is semi permanent
dec hex n=0 for analogue adapter ab2, n=1 for analogue adapter ab1
1 1 High Layer Telephony
2 2 High Layer Compatibility with Fax G2/G3
S108+n=
0 * 0 No High-Layer-Compatibility information element will be sent
0
S118= Bit dec hex Bit mapped register
69
To Next Page
Loading...
