DA180 series basic AC servo drive Preface
-I-
Preface
Thanks for choosing DA180 series basic AC servo drive (DA180 drive for short).
DA180 drive is a new generation of basic servo drive that INVT develops, using the modular design,
USB communication with the upper computer software, and bus control options Modbus and
CANopen. In addition, DA180 drive supports online and offline inertia identifying, gain switching, auto
and manual notch filters, auto and manual vibration control filters, medium-frequency vibration
suppression, internal point-to-point (PTP) control, fully-closed loop control, and multiple types of
encoders.
The electromagnetic compatibility design enables DA180 drive to provide strong anti-electromagnetic
interference capacity but also achieve low noise and electromagnetic interference weakening in the
application sites.
This manual describes the installation, wiring, parameter setting, fault diagnosis, and daily
maintenance. Read this manual carefully before installing DA180 drive so that it works properly.
If the product is ultimately used for military affairs or weapon manufacture, it will be listed on the
export control formulated by Foreign Trade Law of the People's Republic of China. Rigorous reviews
and necessary export formalities are required before the export.
INVT reserves the right to update manual information without prior notice.
To Next Page
Loading...
Need help?
General
