INVT DA180-S2R8SG0

DA180 series basic AC servo drive Operating and running
-68-
5. In parameter setting mode, press SHIFT to move the cursor left and then press UP/DOWN to
change the setting for the MSB.
6. After parameters are set, press SET to save the parameter settings or execute commands.
7. After parameters are set, the LED panel displays (if the parameters are storage
parameters and P0.17 is set to 0 [Individually]) or (if the parameters are
non-storage parameters or P0.17 is set to 1 [In batches]). Then the parameter mode is switched
back automatically.
8. Set long parameters (with 6 digits at least).
SHIFT
SHIFT
SHIFT
UP
DOWN
SET
UP DOWN
SHIFT UP
DOWN
SHIFT
SET
SHIFT
UP
DOWN
SET
MODE
5.2.2 Common monitoring mode
After the drive is powered on, the LED panel enters the common monitoring mode by default. It
displays the names of monitoring parameters for 2.5 seconds, and then the values. You can press
MODE to return to the parameter name display screen. Then you can press UP/DOWN to switch
between monitoring parameters. For details, see section 10.3 "Common monitoring parameters". The
monitoring parameters that are displayed by default can be set by P0.15. If no operation is performed
on the non parameter value display screen in 20 seconds, the common monitoring parameter screen
is displayed.
Operation flowchart
UP DOWN
DOWN
DOWN
UP
UP
MODE
Hold the key for 2.5s
MODE
Hold the key for 2.5s
MODE
Hold the key for 2.5s