Inxpect SRE 200 Series

To Next Page

To Previous Page

134

12. Appendix

12.5.2 Checklist

Question Yes No

Have the safety rules and regulations been observed in compliance with the directives and standards

applicable to the machine?

Are the applied directives and standards listed in the declaration of conformity?

Does the ESPE comply with the required PL/SIL claim limit and PFHd in accordance with EN ISO

13849-1/EN 62061 and the required type in accordance with EN 61496-1?

Is access to the dangerous area only possible through the detection field of the ESPE?

Have appropriate measures been taken to detect any persons in the dangerous area?

Have the safety devices been secured or locked to prevent their removal?

Are additional mechanical protective measures fitted and secured against manipulation which

prevent reaching below, above, or around the ESPE?

Has the maximum stopping time of the machine been measured, specified, and documented?

Has the ESPE been mounted such that the required minimum distance from the nearest hazardous

point has been achieved?

Are the ESPE devices properly mounted and secured against manipulation after adjustment?

Are the required protective measures against electric shock in effect (protection class)?

Is the control switch for resetting the protective devices (ESPE) or restarting the machine present

and correctly installed?

Are the outputs of the ESPE integrated according to the required PL/SIL in accordance with EN ISO

13849-1/EN 62061, and does the integration correspond to the circuit diagrams?

Has the protective function been checked in compliance with the test notes of this documentation?

Are the specified protective functions effective at every operating mode that can be set?

Does the ESPE activate the switching elements?

Is the ESPE effective over the entire period of the dangerous state?

Once initiated, will a dangerous state be stopped when switching the ESPE on or off, when changing

the operating mode, or when switching to another protective device?

Inxpect SRE 200 Series - Page 134