Inxpect SRE 200 Series - 3.7 Fieldbus communication (PROFIsafe)

30
Inxpect SRE 200 Series| Instruction manual v1.5 DEC 2023 |Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
3. Get to know Inxpect SRE 200 Series
Page Function
Settings Configure the sensor groups.
Choose the detection fields dependency.
Enable the anti-tampering functions.
Synchronize more control units.
Configure the inputs and outputs function.
Perform the configuration backup and load a configuration.
Download the log.
Perform the sensor Node IDassignment.
Other general functions.
Admin Configure and manage the users.
Enable the SD Backup and the SDRestore.
Perform a factory reset.
Configure, show, and change the Network parameters (if available).
Configure, show and change the MODBUS parameters (if available).
Configure, show and change the Fieldbus parameters (if available).
Set labels for control units and sensors.
Validation Start the validation procedure.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Troubleshooting" on page85.
REFRESH
CONFIGURATION
Refresh configuration or ignore unsaved changes.
User Change user profile.
Modify account settings.
Control unit Retrieve control unit information.
Close the connection with the control unit and allow it to connect to another control
unit.
Change the language.
3.7 Fieldbus communication (PROFIsafe)
3.7.1 PROFIsafe support
The safety communication using PROFIsafe is available on all the control units provided with the PROFIsafe
interface. For details, see "Control units" on page16.
3.7.2 Communication with the machinery
The Fieldbus makes the following actions possible:
l
Choose from 1 to 32 preset configurations dynamically.
l
Read the status of the inputs.
l
Control the outputs.
l
Read the target data.
l
Mute the sensors.
l
Enable the restart signal.
l
Enable the system recondition signal.
For details, see the PROFIsafe communication Reference guide.