3.6.3 Authentication
The application can be downloaded free of charge at https://tools.inxpect.com.
Different user levels are available. The Admin user is in charge of user management. All the passwords can be set
through the application and then saved on the control unit.
3.6.4 User levels
These are the functions available for each user level:
Observer Expert Engineer Admin Service*
Read system configuration
x
x x x x
Validation
-
x x x x
Download log files - x x x x
Sensor setup (e.g., Node ID)
and configuration
- - x x
-
Digital I/O configuration -
-
x x
-
Backup / Restore
configuration
-
-
x x
-
Network and Fieldbus
settings (Network and
MODBUS parameters,
PROFIsafe F-addresses and
endianness, FSoE Safe
Address), and System labels
-
- -
x
-
Control unit firmware upgrade -
- -
x
-
User management -
- -
x
-
SD Backup and SD Restore (if
available)
-
- -
x
-
Technical support and
maintenance
-
- - -
x
Debug and statistical
information
-
- - -
x
Note*: Service user can be enabled/disabled by the administrator. Since only Inxpect technicians are allowed to
access as Service, the Service user is protected by an activation code.
3.6.5 Main menu
Page Function
Dashboard Display main information on the configured system.
Note: the messages show the same information in the log files. For the meanings of
the messages, see the chapters on logs in "Troubleshooting" on page85.
Configuration Define the monitored area.
Configure the sensors, their shape (for 5.x sensors), and the detection fields.
Configure the sensors and the detection fields.
Define the dynamic configurations.
Choose the safety working mode.
Enable the static object detection option.
Set the restart timeout.
3. Get to know Inxpect SRE 200 Series
Inxpect SRE 200 Series | Instruction manual v1.5 DEC 2023|Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
29
To Next Page