EasyManua.ls Logo

Inxpect SRE 200 Series - 12.2 Disposal; 12.3 Service and warranty; 12.4 Intellectual property; 12.5 Checklist for installing ESPE

Inxpect SRE 200 Series
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12.2 Disposal
Inxpect SRE 200 Series contains electrical parts. As set forth in European Directive 2012/19/EU, do not
dispose of the product with unsorted urban waste materials.
It is the responsibility of the owner/distributor to dispose of these products, as well as other electrical
and electronic equipment, through specific waste collection facilities indicated by the waste disposal
services.
Correct disposal and recycling will contribute to the prevention of potentially harmful consequences to
the environment and human health.
For more detailed information about disposal, contact the waste disposal services or the representative
from whom you purchased the product.
12.3 Service and warranty
12.3.1 Technical Support
Inxpect SpA
Via Serpente, 91
25131 Brescia (BS) - Italy
Tel: +39 030 5785105
email: safety-support@inxpect.com
website: www.inxpect.com
12.3.2 How to return the product
If necessary, complete the request with information about the return on the website
www.inxpect.com/industrial/rma. Then, return the product to the local distributor or exclusive distributor. Use
the original packaging. Shipping costs are at the customer's expense.
Area distributor Manufacturer
Note distributor information here: Inxpect SpA
Via Serpente, 91
25131 Brescia (BS)
Italy
www.inxpect.com
12.3.3 Service and warranty
Refer to www.inxpect.com for the following information:
l
terms, exclusions and cancellation of the warranty
l
general conditions of the Return Merchandise Authorization (RMA)
12.4 Intellectual property
12.4.1 Trademarks
EtherCAT® and Safety over EtherCAT® are registered trademarks and patented technologies licensed by Beckhoff
Automation GmbH, Germany.
12.5 Checklist for installing ESPE
12.5.1 Introduction
Collecting the details relating to the following items is mandatory no later than when the system is commissioned
for the first time.
This checklist should be kept with the machine documentation to serve as a reference during periodic tests.
This checklist does not replace the initial commissioning or regular inspection by qualified safety personnel.
12. Appendix
Inxpect SRE 200 Series | Instruction manual v1.5 DEC 2023|Inxpect SAF-IM-200S_5m_7_00047_en_v1.5|© 2021-2023 Inxpect SpA
133

Table of Contents