Inxpect SRE 200 Series - 12. Appendix; 12.1 System software

To Next Page

To Previous Page

132

12. Appendix

Contents

This section includes the following topics:

12.1 System software 132

12.2 Disposal 133

12.3 Service and warranty 133

12.4 Intellectual property 133

12.5 Checklist for installing ESPE 133

12.1 System software

12.1.1 Introduction

The aim of this appendix is to provide and clarify the information related to the system software. It includes the

information necessary for the integrator during the installation and integration in accordance with IEC 61508-3

Annex D.

Considering that Inxpect SRE 200 Series is an embedded system provided with a firmware already deployed on

board, no software integration is required by the system installer or by the end user. The following paragraphs

analyzes all the information required in IEC 61508-3 Annex D.

12.1.2 Configuration

The system configuration can be performed by means of a PC-based configuration tool, called the Inxpect

Safetyapplication.

The system configuration is described in "Installation and use procedures" on page65.

12.1.3 Competence

Although no competence is required for software integration, a skilled person is required for system installation

and configuration, as described in "Installation and use procedures" on page65.

12.1.4 Installation instructions

The firmware is already deployed on the hardware, the PC-based configuration tool includes a self-explanatory

setup installer.

12.1.5 Outstanding anomalies

At the moment of the issue of this document, no software/firmware anomalies or bugs are known.

12.1.6 Backward compatibility

Backward compatibility is guaranteed.

12.1.7 Change control

Any change proposal suggested by the integrator or the end user should be forwarded to Inxpect and evaluated

by the Product Owner.

12.1.8 Implemented security measures

Firmware upgrade packages are managed by the Inxpect Technical Support and are signed to prevent the use of

unverified binary files.